Comparisons
Aggregate Cooling vs Drum Injection of Nitrogen
If you can cool the stone and the sand, you are cooling most of the mix. If you cannot, or if the load still misses after batching, drum injection is the method that works on the concrete you actually have.
On this page
Why aggregates matter more than people think
In a normal concrete mix, aggregates are most of the mass. Their temperature often dominates the temperature of the fresh concrete. A stockpile that has been sitting in the sun can undo a lot of careful work on the mix water. That is why plants that take summer temperatures seriously spend time on shade, inventory timing, and, where it is appropriate, wetting or other aggregate cooling.
There are more elaborate methods as well, used on some projects and in some climates: cooling with air, with water systems, or with other plant-side arrangements. We will not pretend to catalogue every system, or to rate products we do not supply. The point is simpler. If you can lower the temperature of the materials that make up most of the load, do that first.
Aggregate cooling has limits of its own. Humidity can reduce the help you get from evaporation. Water used on stockpiles has to be compatible with the mix. Not every yard has the space or the time. And once the materials are in the drum, stockpile practice cannot adjust that load.

What drum injection is doing instead
Drum injection puts liquid nitrogen into the fresh concrete in the truck and cools by evaporation. It does not require you to have cooled the aggregates perfectly, and it can answer to a load that arrived hotter than the last one. That makes it a field method as much as a plant method. It is often used at a truck bay at the plant, and it can also be used at the point of placement when the haul would undo a plant-side success.
It is not an excuse to ignore the stockpile. A plant that lets aggregates bake and then asks nitrogen to remove all of that heat on every truck is spending money to correct a yard problem. Use both when both are needed. Use stockpile practice alone when it already gets you inside the cap.
Choosing, or combining, the two
If your summer problem is mostly a hot yard and a moderate cap, invest in the yard. If your problem is a tight cap, a locked mix, a long haul, or a pour that has to be trimmed load by load, plan on injection even if the stockpiles are well run. If your problem is a little of both, combine them and you will usually use less of the expensive lever.
Point-of-placement work tilts toward injection, because you are no longer standing next to the stockpile. Multi-plant pours tilt the same way, unless every plant is running the same aggregate discipline and the same leaving temperature. Campus work that repeats for weeks can justify better yard practice and a standing hookup at once.
See drum injection and a ready-mix summer plan for the two sides of this choice.
An honest boundary
We supply nitrogen injection, not aggregate-cooling plants. That is a reason to be careful in this comparison, not a reason to oversell the lance. If your engineer or your producer already has an aggregate-cooling plan that meets the specification, stay with it. If they do not, and the pour date is coming, injection is the method we can mobilise to the bay.
Is wetting stockpiles always a good idea?
Only when it is compatible with the mix and the specification, and when it is done as a controlled practice rather than an afterthought. Ask the person responsible for the mix.
Can nitrogen cool aggregates instead of the drum?
Our work is injection into fresh concrete, typically in the drum or the mixer. Aggregate-side systems are a different kind of plant investment.
If we improve the yard, will we still need injection?
On a moderate cap, maybe not. On a tight cap or a long haul, maybe yes. The remaining gap is the number that matters.
Related Pages
Send Us the Spec and the Pour Date
Tell us the maximum placement temperature, the volume, the location, and when you are pouring.