Guides
ACI 207 and Mass Concrete Thermal Control
ACI 207 is the usual reference when a project starts talking about mass concrete, peak temperature, and thermal differentials. It is guidance for that problem. It is not a nitrogen-injection manual, and it is not your contract.
On this page
What ACI 207 is for
ACI Committee 207 has long published guides on mass concrete and on the thermal behavior of large placements: heat of hydration, temperature rise, cracking risk, and the practices used to control them. Specifications often point to that body of work, or write project-specific mass-concrete clauses in the same spirit. The edition your project names, and the project document itself, are the texts that govern.
We will not restate the committee’s definitions, temperature limits, or design methods here as if they were ours. Those values change with the document and with the project. A page that pretended to be a pocket ACI 207 would be misleading. If you need the definition of mass concrete or a particular differential, read the specification and the cited guide.
What we can say is how our work sits next to that guidance. Mass-concrete practice is about the temperature history of a thick section, not only the temperature of a truck. Precooling is one tool in that practice. Monitoring, mix design, protection, and sometimes postcooling are others.

Where precooling belongs in a 207-style plan
Lowering the placement temperature lowers the starting point of the temperature history. All else equal, that can reduce the peak. Nitrogen injection is a way to do that precooling without adding water, and to do it on each load of a large pour. Ice and chilled water are other ways, bounded by the mix.
Precooling is not the whole thermal control plan. A 207-style plan still has to deal with the mix’s heat, the section, the environment after placement, and the way temperatures will be measured and acted on. If the plan also requires embedded cooling pipes or a particular insulation sequence, those are separate scopes. See precooling versus postcooling.
Documents we will and will not write
We will help describe the cooling scope and the fresh-concrete temperature record so they can be cited in a thermal control plan or a submittal. We will not write the plan, stamp it, or interpret ACI 207 on behalf of the engineer of record. If a reviewer wants a calculation of temperature rise, that calculation belongs to the engineer, using the mix and the section on the project.
This boundary is not bureaucratic fussiness. It is how you avoid a cooling contractor accidentally becoming an unpaid designer, and how you avoid a plan that no one is actually responsible for.
How to use this on a job
Read the mass-concrete clause and any cited ACI 207 document. List every temperature limit and every required method. Send those pages with the volume and the date. We will tell you whether injection is a sensible precooling method for what the plan is trying to do, and what we can document.
Companions: mass concrete cooling, thermal cracking, and temperature differential.
Does ACI 207 require liquid nitrogen?
No. It is guidance on mass concrete and thermal control. Nitrogen is one precooling method a plan may use. Your specification governs.
Can you provide the temperature-rise calculation?
That belongs to the engineer using the project mix and section. We size and document the cooling scope.
Is ACI 305 the same conversation?
No. 305 is the usual hot-weather concreting reference. 207 is the usual mass-concrete thermal reference. A job can involve both.
Related Pages
Send Us the Spec and the Pour Date
Tell us the maximum placement temperature, the volume, the location, and when you are pouring.